Monday, March 26, 2012

Service that RV Generator!



For a gasoline generator you should start and run the generator with at least a half rated load for a minimum of two hours every month. It is extremely important that you run it with this minimum rated load. Generators are designed to run with a load placed on them. Our motor home has a 4,000 watt generator so I can either turn the roof air conditioner on in the summer time, which is about 2,000 watts or I can use a couple of small portable electric heaters if it's cold out. It's always better to let your generator run for longer periods than it is for short periods. Check your generator owner's manual for load ratings specific to your unit.

Other maintenance intervals for generators are based on usage. Your generator set will have an hour meter so you can monitor the usage. Consult your owner's manual for maintenance intervals.

Changing the oil and filters on a regular scheduled basis and for seasonal changes is just as important for your generator as it is for your automobile. For extended storage requirements consult your generator owner's manual.

Happy RV Learning!
Mark Polk
RV Education 101

Learn about Mark's books, eBooks and DVDs at RVbookstore.com
Read more »

Copyright by Mark Polk owner of RV Education 101 – all rights reserved

Monday, March 19, 2012

What's the condition of your RV battery?

The topic of RV batteries comes up quite often among RVers, and there is good reason for it. Did you know the average life for RV batteries with limited battery care and maintenance is only 2 to 3 years, and that 85% of all 12-volt batteries manufactured in the U.S. die before they should? Replacing two or more deep cycle batteries every couple years can get expensive.

If you really think about it it’s not just RVers who deal with battery problems; if you own a riding lawnmower, a motorcycle, golf cart, automobile, boat or an RV you have probably experienced problems with batteries at one time or another.

Some of the reasons for these battery related problems are undercharging, overcharging, not recharging a discharged battery in a timely manner, lack of maintenance, and a lack of understanding what is required to properly maintain batteries.

The leading cause of battery failure is a condition called sulfation. When a battery is improperly charged, not re-charged in a timely manner, or allowed to self discharge small crystals of sulfuric acid from the battery’s electrolyte start to form on the charge plates. This sulfate material eventually cannot be converted back into active plate material and the battery is ruined.

This occurs frequently when a battery remains discharged for an extended period of time. These crystals act as a barrier, stopping the battery from ever accepting a full charge again regardless of how long you charge the battery. Once this happens, the power and longevity of the battery is severely reduced and your battery becomes one of the 85% that die before it should. Sulfation begins when a battery’s state of charge drops below 80%, or 12.4 volts.

I mentioned a moment ago that overcharging was one reason for batteries dying early. This is a common problem with RV’s. The RV converter has a built in battery charger and most owners are under the impression that if you leave the RV plugged in when it is being stored it will keep the batteries topped off. Keeping the batteries topped off is extremely important, but the problem is many older RV converter chargers provide a constant charge of about 13.5 volts which is too high for fully charged batteries. When this happens the electrolyte is boiled off resulting in an early death for the batteries.

Another problem is not charging the batteries at all when the RV is in short or long term storage, or not recharging a discharged battery in a timely manner and letting it sit in that condition for extended periods of time. Both of these problems result in early battery death too.

Even for someone with a decent understanding of batteries and battery maintenance I had a few of my own batteries become statistics in the past. Then I discovered a way to prevent all of these battery related problems for good. It was a product that charges, maintains and conditions the batteries.

There are a few of these products on the market. The one I use is called The Battery Minder. What I mean by conditioning the battery is that the manufacturer of the Battery Minder has developed a simple but extremely effective circuitry that can safely dissolve the sulfation on the plates and restore much, if not all of the lost power. The reason the Battery Minder works so well is because it not only charges the battery, it maintains and de-sulfates the battery and won't overcharge it.

I'm not saying that you will never have to check the water levels or routinely inspect your batteries again, but this product will simplify your battery maintenance and extend the life of your batteries. It can even reverse sulfation on batteries that are already affected by this condition, if caught in time. It’s not very often that I endorse a product but the Battery Minder is one that I have been using for many years now, and through using it I have seen proven results.

When I'm not using the RV I hook the battery minder to the battery and let it go. Through proper charging and maintenance you can easily double the life expectancy of your RV batteries.

If you would like to learn more about your deep cycle batteries check out:
Deep Cycle Batteries DVD
Deep Cycle Battery Care and Maintenance E-Book

Happy RV Learning!
Mark Polk
RV Education 101

Learn about Mark's books, eBooks and DVDs at RVbookstore.com
Read more »

Copyright by Mark Polk owner of RV Education 101 – all rights reserved

Tuesday, March 13, 2012

Do you Replace your Automobile Antifreeze?

Today I want to talk briefly about automotive antifreeze, and the need to regularly flush the coolant system and add new antifreeze to the vehicle cooling system.

 The average consumer doesn’t relate changing antifreeze in their vehicles like they relate to changing the engine oil on a regular basis. The coolant system of any vehicle performs a very important job; to prevent the heat producing engine from overheating and quite possibly seizing up. When you don’t flush and replace the antifreeze periodically rust, scale and corrosion can build up in the radiator and engine coolant passages, and eventually result in an overheated engine.

Let’s talk a minute about what a vehicle coolant system is intended to do. First of all, if an engine did not have methods for transferring the heat that is produced through combustion and friction the hot metal parts would melt down and seize up. Heat that the engine produces is basically removed through the exhaust system and through the cooling system. All heat producing sections of an internal combustion engine need to be cooled, including the combustion chamber, heads, cylinder walls and the engine block itself. The way this is done is by circulating coolant around these heat producing areas of the engine. The coolant picks the heat up and releases much of it as it circulates through the vehicles radiator.

Water does a good job helping to cool an engine but it has some drawbacks. Most importantly it freezes quickly during cold winter temperatures. Water can also cause certain metals to rust and corrode over time. This is why the water in a vehicle cooling system is mixed with what we refer to as antifreeze. Glycol antifreeze does several things to help your engine:

1) It helps to lower the freezing point of water.

2) The corrosion inhibitors that are added help prevent scale and rust build-up in the cooling system.

3) It provides protection against boiling in the hot summer months.

4) Antifreeze helps keep the engine operating at its most efficient temperature regardless of operating conditions and outside temperatures.

When we don’t flush and replace the antifreeze at recommended intervals these chemicals start to break down and cannot perform the job as effectively as new antifreeze can. Just like used engine oil breaks down and needs to be replaced for maximum lubrication and cooling performance.

How many of you have ever witnessed a vehicle sitting along the side of a road with steam billowing out of the engine compartment from overheating? I cannot count the number of times I have seen this. Many times the cause is due to the failure of a part within the cooling system. If a radiator hose, heater hose, water pump, thermostat or fan belt fails the result is an overheated engine. Or, if the coolant system hasn’t been flushed and the antifreeze replaced for several years the result is an overheated engine. The bottom line is periodic inspections of the cooling system components, and flushing and replacing antifreeze at recommended intervals will add years of life to the vehicles engine and prevent untimely breakdowns.

Keep in mind that glycol antifreeze is poisonous to humans and pets and that it needs to be disposed of properly. You should follow the guidelines in your vehicle owner’s manual for flushing and replacing antifreeze and make sure you are using the proper type of antifreeze recommended for your particular vehicle.

Remember, getting here is supposed to be half the fun! Add the vehicle cooling system to your pre-trip inspection if you don’t already include it.

Happy RV Learning!
Mark Polk
RV Education 101

Copyright by Mark Polk owner of RV Education 101 – all rights reserved

Learn about Mark's books, eBooks and DVDs at RVbookstore.com
Read more »

Tuesday, March 6, 2012

Defensive Driving = Smart Traveling

More than 30,000 people in the United States die each year on the road! Drive defensively! Stay alert and monitor what is going on around you at all times. Here are some tips:

Use your mirrors.


Avoid driving or pulling your RV during bad weather and high winds. Because of the size and mass of RV’s it can be extremely dangerous to travel during periods of high winds. It’s better to get to your destination one day later, than to risk traveling in bad weather.
Complete a “Pre-Trip Checklist” before you head out on the road. Simple checks like checking your tires, lights, hitch work and other items all contribute to a safer trip. You should make these checks everyday before traveling.


Limit your driving time to 5 or 6 hours a day (300 to 350 miles). Not only will you be more alert, but you will arrive at the campground with plenty of day light to get set up and settled in before it gets dark outside. This gives you a chance to unwind and get rested for another day of travel, and to enjoy some of the amenities the campground has to offer.

Eventually you will have to pass another vehicle in your RV. It's not difficult to pass but with a large RV it requires more space and time than the average automobile. Make sure you have plenty of room and use your turn signals to change lanes. Accelerate until you are past the other vehicle and you can see both of their headlights in your side mirror. Signal again to return to the other lane and pull back in. Maintain your speed ahead of the vehicle you just passed.

Plan your trip, travel safe and smart and enjoy your RV experiences. Remember, getting there is half the fun!


Here are some helpful full length DVDs:

Happy RV Learning!
Mark Polk
RV Education 101

Copyright by Mark Polk owner of RV Education 101 – all rights reserved

Learn about Mark's books, eBooks and DVDs at RVbookstore.com